I was looking for a bench for my daughter’s room when I came upon this coffee table at a local thrift store. When I saw it I liked its clean lines and decided that it could also be used as a bench.
Located near a sunny window, this bench has become a prized spot in our house.
It has even inspired imaginative play. How could it not?

This bench is for my reader and writer: hence the vintage typewriter, books, and writing journal.

How to convert this rickety old coffee table into a nice sturdy bench:

1. Some of the pieces had shifted out of place over time so they needed to be tapped back in place and glued.

2.  The legs were wobbly so the wing nuts were tightened but not before the washers were replaced by larger ones. The smaller ones were getting squeezed into the wood and therefore not doing their job anymore.

3. To create a lip, you’ll need to cut the long edge off of what will become the back side of the bench. This lip will help keep the pillows in place when the bench is complete but is not needed if your table/bench doesn’t allow for it.  Measure and clamp a guide board onto your table. This will allow you to cut a nice straight line.

4. Run the skill saw along the edge of the board; cutting a strip off one of the long sides.

5. Turn the strip up on end (becomes the lip) and glue into place.  Also add a few screws from the bottom. This allows the table (now bench) to go up against the wall and also adds a bit of a design element.

6. Paint if you like or touch up with stain.

Find out more about the mattresses and tips on how to make them:
Thrift Store Coffee Table Turned Princess And The Pea Inspired Bench: Making Mattresses

Bookmark It

This “princess” has discovered something under her mattress.

Making the mattresses:
1. Make a pattern by laying a piece of salvaged packing paper on the top of the bench. Run the edge of a crayon around the edge of the bench: marking on the paper the outline of the bench shape. If your bench is rectangular in shape then your job is easier: just measure your bench.
2. Add about ¼ inch all the way around to allow for the loft of the mattress and another ¼ inch for the seam allowance.
3. The mattresses are made like basic pillows.
4. To fill mattresses, I encourage you to use recycled materials.
-an old comforter: layer the pieces to achieve desired loft
-stuffing from salvaged pillows
-recycled fiber stuffing (I’ve only seen this sold in bulk). or even dryer lint. (try asking at industrial drying places for large amounts)
-down from salvaged comforters or jackets

The top blue mattress (picture above) has been given a quilted look by tying it off at regular intervals with super soft alpaca yarn (left over from knitting project).

This mattress was made from scrap fabric from another project. It is filled with two layers of an old comforter of ours that had become faded and torn. It is made like a basic pillow then I hand quilted it using embroidery floss.

This mattress was made from a cotton thrift store shower curtain (not the liner). I used the curtain’s own hem to edge it.

This mattress was made from a second hand tablecloth with a bleach stain on it. No problem, I was able to use the un-stained piece. It was made like a basic pillow then I machine sewed all around the edge. It is filled with recycled fiber stuffing.

This mattress was made from left-over fabric from the curtains I made for that room. Although this fabric was not recycled, the stuffing is. Inside is two layers of an old but clean comforter.

So far I’ve made 6 mattresses for our bench. This pile of mattresses will continue to grow as I come across other fabric to recycle.

Find out more about the bench and tips on how to alter it:
Thrift Store Coffee Table Turned Princess And The Pea Inspired Bench: Altering Bench

Bookmark It