Category Archives: home décor (recycle and upcycle)

Chandelier Make-Over: When Switching To Energy Efficient Light Bulbs, Try Frosting Glass Shades To Hide Unsightly Bulbs

DIY Frosted Glass Chandelier Shade

I wanted to “green” up our chandelier but the new light bulbs didn’t look good.

First I tried to achieve a frosted look by using etching cream. (I used Armour Etch Glass Etching Cream. See pictures below.)

Then I thought maybe I could paint the inside but wanted it to be transparent. Also I wanted the resulting look of the chandelier to be neutral.

I found this site (http://lifehacker.com/399731/increase-your-privacy-with-16-diy-window-frosting) which describes how they put acrylic wall glaze on windows to give a milky opaque look to increase privacy. I decided to try it on my chandelier shades.

DIY Frosted glass Shade Close-up

I think it turned out terrific!

glass chandelier shade before frosting up-close

This is a before picture.

DIY frosted glass chandelier Shades

chandelier with glass shades before frosting

This is also a before picture. The kids and I like to decorate this chandelier according to the season or holiday.

How to:

Find some acrylic glaze. I went to my local Habitat for Humanity and would you believe they had some. I found Behr brand glazing liquid. You might want to ask around to see if anyone had some in their garage. It only takes a small amount.

Clean the shades and let dry.

Paint a thin layer on the inside of the shades.

The brush bristles left lines in the paint that were noticeable on the top half so I used a paper towel to give it a ragged on look instead. The bottom half has three layers on it. Let dry between coats.

The benefit of this solution is that the glaze can be scrubbed out if you ever change your mind.

etch glass chandelier shades

These shades have the etching cream on them.

etched glass chandelier shade

Here is what it looked like after using the etching cream two times. It has a cool patchy look but not what I want for this project. I tried a third time without sufficient results. At Armour Products website it says that this product is not recommended for large areas. Large is relative; I thought they meant large like a window.

Bedroom Blizzard: Paper Snowflake Decor

Paper Snowflakes; Snowing in bedroom.

 

Add a little fun to your life by making a winter wonderland in the comfort of your own home.

Pretty Paper SnowFlake

This snowflake was made from an invoice I received. I’ve been collecting these invoices and instead of sending them to be recycled (which is good too) I saved them to make a blizzard. Invoices work because the little bit of writing on the back isn’t overly noticeable. Also, I try to work with the whitest parts.

Paper Snow Flakes

Put a few of the snowflakes directly on the wall. Also, you can hang one snowflake under another.

Bedroom Blizzard: Paper Snowflakes

Hang snowflakes at different levels for a more natural snowing affect. I used salvaged fishing wire to hang some of the snowflakes. I have some fishing wire found during beach clean-ups. Parts that aren’t too tangled can be washed and reused.

Falling Paper Snow Flakes

It’s so lovely to go in that room and look up (or if you are lying on the bed and looking up); it makes you feel like the snow is really falling down all around. I couldn’t capture it in a picture so you’ll have to make it to see for yourself.

How to tips:

Paper snowflakes can be made with scrap paper, invoices, and used printer paper that still has a lot of white left. Have you ever printed stuff from the internet and the last page that prints only has the web address on it?

I save my favorite snowflakes to use again. Store them where they can stay flat such as in an unwanted (salvaged) book. The added benefit is that pressing them in a book flattens them out nicely.

Note: I tried ironing my snowflakes. (That’s not a sentence you see too often.) What I discovered is that some invoices such as from Amazon are printed with a heat printer of some kind; thus, rendering one side of the snowflake black when ironed. Best to test your paper first if ironing.

Thrift Store Coffee Table Turned Princess And The Pea Inspired Bench: Altering Bench

Princess and the Pea inspired bench group picture

I was looking for a bench for my daughter’s room when I came upon this coffee table at a local thrift store. When I saw it I liked its clean lines and decided that it could also be used as a bench.
Located near a sunny window, this bench has become a prized spot in our house.
It has even inspired imaginative play. How could it not?

Altered Princess and the Pea bench
This bench is for my reader and writer: hence the vintage typewriter, books, and writing journal.

How to convert this rickety old coffee table into a nice sturdy bench:

altered bench before
1. Some of the pieces had shifted out of place over time so they needed to be tapped back in place and glued.

glue the bench
2.  The legs were wobbly so the wing nuts were tightened but not before the washers were replaced by larger ones. The smaller ones were getting squeezed into the wood and therefore not doing their job anymore.

alter bench washers
3. To create a lip, you’ll need to cut the long edge off of what will become the back side of the bench. This lip will help keep the pillows in place when the bench is complete but is not needed if your table/bench doesn’t allow for it.  Measure and clamp a guide board onto your table. This will allow you to cut a nice straight line.

alter bench cutting guide
4. Run the skill saw along the edge of the board; cutting a strip off one of the long sides.

alter bench cutting
5. Turn the strip up on end (becomes the lip) and glue into place.  Also add a few screws from the bottom. This allows the table (now bench) to go up against the wall and also adds a bit of a design element.

altered bench back
6. Paint if you like or touch up with stain.

Find out more about the mattresses and tips on how to make them:
Thrift Store Coffee Table Turned Princess And The Pea Inspired Bench: Making Mattresses

Thrift Store Coffee Table Turned Princess And The Pea Inspired Bench: Making Mattresses

After finding and altering a coffee table into a bench, I set to work making it cozy. It needed to be a comfortable sitting and/or reading spot. That meant a pillow of sorts but then I got a clever idea: to add a pile of mattresses like in the story “The Princess and the Pea.” How fun! My girls liked the idea too. The idea was to have the mattresses look home-made like a pile of Grandma’s quilts. I wanted them to have lots of playful variation, yet still look nice together. And, of course, I wanted it to be made with lots of recycled materials.

Princess on Princess and the Pea inspired bench

This “princess” has discovered something under her mattress.

Making the mattresses:
1. Make a pattern by laying a piece of salvaged packing paper on the top of the bench. Run the edge of a crayon around the edge of the bench: marking on the paper the outline of the bench shape. If your bench is rectangular in shape then your job is easier: just measure your bench.
2. Add about ¼ inch all the way around to allow for the loft of the mattress and another ¼ inch for the seam allowance.
3. The mattresses are made like basic pillows.
4. To fill mattresses, I encourage you to use recycled materials.
-an old comforter: layer the pieces to achieve desired loft
-stuffing from salvaged pillows
-recycled fiber stuffing (I’ve only seen this sold in bulk). or even dryer lint. (try asking at industrial drying places for large amounts)
-down from salvaged comforters or jackets

Girl on Princess and the Pea inspired bench

The top blue mattress (picture above) has been given a quilted look by tying it off at regular intervals with super soft alpaca yarn (left over from knitting project).

Princess and the Pea mattress: blue quilted

This mattress was made from scrap fabric from another project. It is filled with two layers of an old comforter of ours that had become faded and torn. It is made like a basic pillow then I hand quilted it using embroidery floss.

Princess and the Pea mattress: striped shower curtain

This mattress was made from a cotton thrift store shower curtain (not the liner). I used the curtain’s own hem to edge it.

Princess and the Pea mattress: orange plaid

This mattress was made from a second hand tablecloth with a bleach stain on it. No problem, I was able to use the un-stained piece. It was made like a basic pillow then I machine sewed all around the edge. It is filled with recycled fiber stuffing.

Princess and the Pea mattress: striped curtain

This mattress was made from left-over fabric from the curtains I made for that room. Although this fabric was not recycled, the stuffing is. Inside is two layers of an old but clean comforter.

So far I’ve made 6 mattresses for our bench. This pile of mattresses will continue to grow as I come across other fabric to recycle.

Cat sleeping on Princess and the Pea bench

Find out more about the bench and tips on how to alter it:
Thrift Store Coffee Table Turned Princess And The Pea Inspired Bench: Altering Bench

Easy To Make License Plate Bookend

license plate bookends

They say necessity is the mother of invention: that is true. My daughter needed a bookend so I did a little brain storming and dug through the house/garage for inspiration. I easily transformed these license plates into bookends.

bookends made from license plates

How to:

Recycle a license plate by making it into a bookend. All you have to do is bend a license plate over the edge of a table. Easy.

I like the vintage look of these plates left as is but you could be creative and paint them for a modern look.