I had a quad chair bag that I wanted to get rid of but I don’t like to just throw things away. As I was looking it over I thought of the sleeping bag idea. It turned out to be the perfect size for my daughter’s 18inch dolls.
Here is a quad chair carrying sack before being transformed into a cozy doll sleeping bag.
To Make the sleeping bag shell
1. You will notice that the chair carrying sack has a shoulder strap. Keep this strap attached at the top but cut it off near the bottom. I left the strap attached to the sleeping bag and used it as a feature of the finished sleeping bag.
2. Next measure 22.5 inches from the top. Cut a straight line across the bag. You are cutting the bottom of the sack off; save it for making the sleeping bag stuff sack.
3. Turn inside out and stitch along the bottom edge. Use a half inch seam allowance.
4. Turn right side out.
To make the sleeping bag lining and the padding layer
5. Cut a soft piece of fabric (for the lining) and a piece of on old blanket (for the padding). The pieces should measure 23 x 22 inches.
6. Put the lining on top of the blanket piece and fold in half. Folded size= 23 x 11 inches. Also, make sure the lining’s pretty side is facing inside. In other words, if you were to open the sleeping bag and look in, you should see the good side of the lining.
My daughter did all the sewing and I did the design work.
7. Sew along two sides; the long side and the bottom. Use a 5/8 inch seam allowance.
8. Slip the lining into the shell. Make sure the seam edge is on the seam side of the shell. You will need to un-sew the bit where the slit is in the shell. See picture.
9. Fold under raw edge and pin in place.
10. Hand or machine sew the lining to the shell all along the edge. Hand sewing a whip stitch is easier then machine sewing if you used a thick blanket for padding.
To make the stuff sack for the doll sleeping bag:
1. Use the bottom piece of your chair carrying sack. Only the bottom 10 inches are needed so cut off the extra.
2. Fold over the top edge about two inches and sew creating a channel about 3/8th of a inch wide. Leave a one inch gap in your stitch line as seen in picture B.
3. Find an old shoelace or cord. Using an awl or even a sharp pencil, poke two holes for the drawstring (shoelace or cord) to come out. It works best if you poke the hole from the back. The arrow in picture A indicates putting the awl up under there.
4. Attach a large safety pin onto one end of your shoe lace. Go under the flap in picture A and like a caterpillar, inch the safety pin all the way around and back out. Remove the safety pin.
5. Stick the ends of the shoe lace through the holes you made. One should come out each hole. Tie the ends of the shoe lace together. Pull the ends of the string to cinch the bag closed.