Thrift Store Coffee Table Turned Princess And The Pea Inspired Bench: Altering Bench
Posted Aug 25, 09 -Filed Under crafts (recycled materials), furniture, redo/ upcycle, home décor (recycle and upcycle), reuse blankets: old or damaged, reuse down from jackets, reuse fabric from drapes or other, reuse fabric items, reuse sheets, bed sheets, reuse stuffing, from pillows etc., sewing | 7 Comments
I was looking for a bench for my daughter’s room when I came upon this coffee table at a local thrift store. When I saw it I liked its clean lines and decided that it could also be used as a bench.
Located near a sunny window, this bench has become a prized spot in our house.
It has even inspired imaginative play. How could it not?

This bench is for my reader and writer: hence the vintage typewriter, books, and writing journal.
How to convert this rickety old coffee table into a nice sturdy bench:

1. Some of the pieces had shifted out of place over time so they needed to be tapped back in place and glued.

2. The legs were wobbly so the wing nuts were tightened but not before the washers were replaced by larger ones. The smaller ones were getting squeezed into the wood and therefore not doing their job anymore.

3. To create a lip, you’ll need to cut the long edge off of what will become the back side of the bench. This lip will help keep the pillows in place when the bench is complete but is not needed if your table/bench doesn’t allow for it. Measure and clamp a guide board onto your table. This will allow you to cut a nice straight line.

4. Run the skill saw along the edge of the board; cutting a strip off one of the long sides.

5. Turn the strip up on end (becomes the lip) and glue into place. Also add a few screws from the bottom. This allows the table (now bench) to go up against the wall and also adds a bit of a design element.

6. Paint if you like or touch up with stain.
Find out more about the mattresses and tips on how to make them:
Thrift Store Coffee Table Turned Princess And The Pea Inspired Bench: Making Mattresses

If you’re looking for even more re-purposed craft ideas you must check out blah-to-tada.blogspot.com. (Apparently we think alike.) Claire already has accumulated a nice collection of re-uses since she started in January of 2009. Posts range from repurposing handkerchiefs to egg cartons.
Tiny Choices, written by Karina and Jenn, is filled with posts that make us think about the little choices we make daily. One post reminds us to consider what is in our shampoo while another post will make us consider the impact of a new shower curtain. (“New vinyl shower curtains off-gas around 108 different chemicals within the first 28 days of use.”…)
I also like their green-living tips.
Thrift Store Coffee Table Turned Princess And The Pea Inspired Bench: Making Mattresses
Posted Aug 16, 09 -Filed Under Uncategorized, crafts (recycled materials), furniture, redo/ upcycle, home décor (recycle and upcycle), party favors, reuse down from jackets, reuse fabric from drapes or other, reuse fabric items, reuse sheets, bed sheets, reuse stuffing, from pillows etc., sewing, use for yarn scraps | 10 Comments
After finding and altering a coffee table into a bench, I set to work making it cozy. It needed to be a comfortable sitting and/or reading spot. That meant a pillow of sorts but then I got a clever idea: to add a pile of mattresses like in the story “The Princess and the Pea.” How fun! My girls liked the idea too. The idea was to have the mattresses look home-made like a pile of Grandma’s quilts. I wanted them to have lots of playful variation, yet still look nice together. And, of course, I wanted it to be made with lots of recycled materials.
This “princess” has discovered something under her mattress.
Making the mattresses:
1. Make a pattern by laying a piece of salvaged packing paper on the top of the bench. Run the edge of a crayon around the edge of the bench: marking on the paper the outline of the bench shape. If your bench is rectangular in shape then your job is easier: just measure your bench.
2. Add about ¼ inch all the way around to allow for the loft of the mattress and another ¼ inch for the seam allowance.
3. The mattresses are made like basic pillows.
4. To fill mattresses, I encourage you to use recycled materials.
-an old comforter: layer the pieces to achieve desired loft
-stuffing from salvaged pillows
-recycled fiber stuffing (I’ve only seen this sold in bulk). or even dryer lint. (try asking at industrial drying places for large amounts)
-down from salvaged comforters or jackets
The top blue mattress (picture above) has been given a quilted look by tying it off at regular intervals with super soft alpaca yarn (left over from knitting project).
This mattress was made from scrap fabric from another project. It is filled with two layers of an old comforter of ours that had become faded and torn. It is made like a basic pillow then I hand quilted it using embroidery floss.
This mattress was made from a cotton thrift store shower curtain (not the liner). I used the curtain’s own hem to edge it.
This mattress was made from a second hand tablecloth with a bleach stain on it. No problem, I was able to use the un-stained piece. It was made like a basic pillow then I machine sewed all around the edge. It is filled with recycled fiber stuffing.
This mattress was made from left-over fabric from the curtains I made for that room. Although this fabric was not recycled, the stuffing is. Inside is two layers of an old but clean comforter.
So far I’ve made 6 mattresses for our bench. This pile of mattresses will continue to grow as I come across other fabric to recycle.
Find out more about the bench and tips on how to alter it:
Thrift Store Coffee Table Turned Princess And The Pea Inspired Bench: Altering Bench
Eco- gift Wrapping; Ribbon Made From Shirts
Posted Aug 14, 09 -Filed Under eco-friendly living ideas, gift wrapping, eco-friendly, gifts from recycled materials, reuse bags, brown paper, reuse fabric items | Leave a Comment
I do a lot of projects with salvaged clothing. I like finding ways to reuse second-hand clothing (or my own cast-offs) especially if they are flawed in some way and therefore not even good enough to bring to thrift stores.
As a byproduct of another craft project, I had a strip of shirt and thought that it looked like ribbed ribbon. The next time I was wrapping up a gift, I gave it a try.
How to:
Find a suitable shirt.
Using a rotary cutter and a metal ruler cut across the grain in order to achieve a ribbed ribbon look.
Cut strips of fabric an inch or so wide, your preference, but try to keep it even.
I cut one inch strips from the bottom of an old shirt. Next time I’m going to cut a narrower ribbon of a complementary color and place it on top of my other ribbon for a different look.
Give Away: Vintage Arnel’s Mushroom Cookie Jar
Posted Aug 12, 09 -Filed Under give aways | 5 Comments

This super cool mushroom cookie jar (think 1970’s) is looking for a good home. I found it at a local second-hand store and cleaned it up. I have a feeling it has been in someone’s kitchen for a long time. It has a few minor chips around the opening but otherwise is in great condition. The bottom of the jar says Arnel’s; it‘s a collector’s item.
It would be great to store cookies obviously but would also be nice to store craft supplies in your craft room.
Doesn’t it just make you smile?
To win this cookie Jar all you have to do is comment on this post. I’m thinking that I should limit one comment per day per person.
I’ll randomly pick a winner on August 26th. I’ll e-mail the winner!
Important: You must be willing to pay the shipping cost. I’ll carefully pack it up and send it right out to you. Expect a clean but reused box and packing materials (no surprise there).
It should be noted that I don’t take any money for my part.
How To Make Your Own Coffee Pot Character: Fisherman Perc
Posted Aug 1, 09 -Filed Under crafts (recycled materials), party: robot, reuse "trash", reuse cans, reuse glasses/ sunglasses, vintage/ old, reuse pie pan, aluminum, reuse pot, coffee | Leave a Comment
Fisherman Perc

How To:
To make a fun Coffee Pot Character you need to start with an aluminum coffee pot. I found this vintage aluminum percolator coffee pot at a local thrift store.
Fisherman Perc (a pleasant old man who enjoys the quit solitude of a day spent fishing).was made with:
Salvaged bolts for eyes. Drill a hole big enough to insert the bolt. It isn’t difficult to drill through aluminum.
Black valve knob (thing-a ma-gig) was glued on to make a mustache.
Can tabs were glued on to make the ears.
A mini aluminum pie pan with an old canning lid became the hat.
An aluminum angel food cake pan / bunt pan (the center piece) made a perfect neck/ stand.
Extras: Vintage reading glasses, fishing lures, can of “worms,” and small mint tin.
Pieces needed in the assembly of Fisherman Perc.
























